Font size
WorksheetsSEMICONDUCTOR DEVICES QUIZ 2
Total questions: 50
Worksheet time: 25mins
Which of the following terminals does not belong to the MOSFET?
Drain
Gate
Base
Source
Choose the correct statement
MOSFET is a unipolar, voltage controlled, two terminal device
MOSFET is a bipolar, current controlled, three terminal device
MOSFET is a unipolar, voltage controlled, three terminal device
MOSFET is a bipolar, current controlled, two terminal device
The main factor which differentiates a DEMOSFET from an E-only MOSFET is the absence of :
P-N junctions
Insulated gate
Electrons
Channel
The controlling parameter in MOSFET is
Vds
Ig
Vgs
Is
The main application of the enhancement mode MOSFET is :
Amplification
Switching
Tuning
Rectification
The output characteristics of a MOSFET, is a plot of
Id as a function of Vgs with Vds as a parameter
Id as a function of Vds with Vgs as a parameter
Ig as a function of Vgs with Vds as a parameter
Ig as a function of Vds with Vgs as a parameter
The N-channel MOSFET is considered better than the P-channel MOSFET due to its
faster operation
lower input impedance
TTL compatibility
low noise levels
IGBT full form?
Insulated Gate Bipolar Transistor
Isolated Gate Bipolar Transistor
Intrensic Gate Bipolar Transistor
Isolated Gate Bivalent Transistor
Choose the false statement
SCR is a bidirectional device
SCR is a controlled device
In SCR the gate is the controlling terminal
SCR are used for high-power applications
IDENTIFY THE SYMBOL OF THE COMPONENT IN TH EGIVEN FIG...
ZENER DIODE
TUNNEL DIODE
LED
ALL OFTHE ABOVE.
LIGHT EMITTING DIODE WORKS IN ________________ CONDITION.
REVERSE BIAS
NO BIAS
FORWARD BIAS
NONE OF THE ABOVE.
THE SILICON DIODE HAS _____________ VOLATGE DROP.
0.3V
0.9V
0.7V
1V
The principle of a solar cell is same as the photo diode
TRUE
FALSE
SCOTTKY DIODE OPERATES ONLY WITH
Majority Carriers
Minority Carriers
In a photo diode, when there is no incident light, the reverse current is almost negligible and is called
zener current
dark current
photo current
drift current
Schottky junction made up of
Metal to n region
p to n region
metal to semiconductor
metal to insulator
The tunnneling involves_______
acceleration of electrons in p side
movement of electrons from n side conduction band to p side valance band
charge distribution management in both the bands
positive slope characteristics of diode
what is the meaning of rectification?
a process of smoothing using a capacitor
a process of adding impurities to pure materials
a process of converting an alternating current into a direct current by using a diode.
A TRIAC is_______
3 terminal bidirectional switch
3 terminal bilateral switch
2 terminal switch
2 terminal bilateral switch
The given fig. represents
Triac thyristor
Diac thyristor
Capacitive Diode
None of the above
A device that does not exhibit negative resistance characteristics is
FET
UJT
Tunnel diode
SCR
The thyristor is turned -off when the anode current falls below_____
Forward current
Latching current
Holding current
Breakover current
Inverter converts
DC to AC
AC to DC
DC to DC
AC to AC
If the firing angle in an SCR rectifier is decreased, the output is
Increased
Maximum
Decreased
Remain Unaffected
Comparing a triac & SCR
Both are unidirectional devices
An SCR has less time for turn off than Triac
Both are bidirectional devices
All of the above
IGBTs are widely used in high-current applications.
FALSE
TRUE
Does DIAC is work on AC power supply
yes
no
Which image shows the output of a sine-wave after it has gone through a diode? (Half-wave rectified)
Efficiency of a centre tapped full wave rectifier is _________
a) 50%
b) 46%
c) 70%
d) 81.2%
50%
46%
70%
81.2%
The ripple factor of a bridge rectifier is
0.482
0.8l2
l.ll
1.21
To get a peak load voltage of 40V out of a bridge rectifier. What is the approximate rms value of secondary voltage?
0v
14.4v
28.3v
56.6v
DC average current of a full wave rectifier output is (Where Im is the maximum peak current of input) Iav
2 Im/R
Im/π
Im /2π
1.414 Im /π
Peak inverse voltage for a diode is the
maximum voltage that can be applied across the diode in the conducting direction
voltage corresponding to rated maximum voltage
maximum voltage that can be applied across the diode in the non conducting direction
none of the above.
In a bridge rectifier, the output current is flowing through a different pair of diodes alternately.
True
False
In Full wave rectifier , What Transformer is used ?
Step Up
Step Down
Potential
Center Tapped
The basic purpose of a filter is to
Minimize variations in a.c input signal
Remove ripples from the rectified output
Determine the forward biased diodes at the first positive cycle of the source voltage.
D1
D1 & D2
D3 & D4
D1 & D4
SCR is a ……………….. controlled device
Voltage
Current
Voltage as well as current
None of the above
Acronym for LASER is
Light Absorption by Stimulated Emission of Radiation
Light Amplification by Stimulated Emission of Radiation
Light Alteration by Stimulated Emission of Radiation
Light Attenuation by Stimulated Emission of Radiation
3.What are the materials used to make the Tunnel diode?
AlGaAs
ZnTe
Silicon and germanium materials
The oxide layer formed in the MOSFET is
Metal oxide
Silicon dioxide
Poly Silicon oxide
Oxides of Non metals
In which region the MOSFET acts as an amplifier?
cutoff region
saturation region
triode/linear region
none
The principle of a solar cell is same as the photo diode
TRUE
FALSE
Photodiode is used in the detection of
Visible light
Invisible light
No light
Both visible and invisible light
The RMS value of a half wave rectifier current is 10 A. Its value for full wave rectification would be
210π A
102 A
2 A
220π A
For single phase supply frequency of 50 Hz, ripple frequency in full wave rectifier is
500
5
100
10
Efficiency of a half wave rectifier is
50%
60%
40.6%
46%
