NEW
Font size
WorksheetsAUT104 Week 6 Quiz
Total questions: 20
Worksheet time: 10mins
Unsprung mass includes all of these, EXCEPT:
wheel and tire assemblies.
nonindependent axle.
frame/chassis.
outboard brake assemblies.
When a wheel and tire assembly hits a speed bump, the assembly moves upward.
Select one:
True
False
Tech A says that one purpose of the suspension system is to keep the tires in contact with the road. Tech B says that the heavier the weight of the unsprung components, the smaller the reaction force they will generate. Who is correct?
Select one:
Tech A
Tech B
Both A and B
Neither A nor B
Tech A says that yaw is when a vehicle deviates from its straight path. Tech B says that roll is felt during hard braking. Who is correct?
Select one:
Tech A
Tech B
Both A and B
Neither A nor B
The suspension system performs all of the following functions EXCEPT:
Select one:
absorbing the large road forces generated while driving on non-perfect roads.
holding the wheels and tires in the proper orientation.
monitoring the tread wear of each tire.
supporting the weight of the chassis, drivetrain, passenger compartment, occupants, and any additional load.
If a wheel and tire are very light, they will not generate as much ________, so it is easier for the spring to push them back down, maintaining contact with the road.
Select one:
Upward force
Downward force
Reactive force
Applied force
The three terms pitch, roll, and yaw describe the movement of a vehicle around three axes labeled X, Y, and Z. Technician A says that roll occurs when the vehicle is being braked. Technician B says that yaw occurs in a vehicle when the vehicle is being drifted. Who is correct?
Select one:
Technician A
Technician B
Both Technician A and Technician B
Neither Technician A nor Technician B
The ________ is all the parts of the vehicle that are not supported by springs, including the components that follow the road contours, such as wheels, tires, axles, and outboard brake assemblies.
Select one:
Reaction force
Sprung mass
Unsprung mass
Weightless area
________ refers to the lateral movement of the axle housing during turning.
Select one:
Cornering force
Driving thrust
Braking torque
Deflecting force
What type of spring is mounted on a strut suspension system?
Select one:
Leaf spring
Coil spring
Torsion bar
None of the above
Rubber ________ and ________ stops are used to prevent direct metal-to-metal contact between the control arms and the frame if the suspension should reach its maximum limit of travel.
Select one:
Pivot; jounce
Jounce; rebound
Rebound; pivot
Pins; jounce
The front wheels of a vehicle can have a different type of suspension system than the rear wheels.
Select one:
True
False
Tech A says that on short-/long-arm (SLA) suspension systems, the upper control arm is the long one. Tech B says that on SLA suspension systems, the control arms are connected to the frame by ball joints. Who is correct?
Select one:
Tech A
Tech B
Both A and B
Neither A nor B
What is the drawback of a coil spring suspension on a straight axle?
Select one:
Compact design
Light weight
No side-to-side or front-to-back stability
None of the above
What part is this?
Tie rod end
control arm bushing
ball joint
swaybar link
What par is this?
Swaybar bushing
Ball joint
Control arm bushing
Tie rod end
What part is this?
Control arm bushings
Tie rod ends
Swaybar bushings
Tie rod ends
What is this?
Swaybar
Upper Control arm
Lower control arm
Steering knuckle
What part is this?
Shock absorber
Coil spring
Steering damper
Coil over strut
What part is this?
Center link
Tie rod
Idler arm
Pitman arm
