According to RA 7920 the member of the REE shall hold office for a term of ____ year from the date of appointment or until their successors shall have been appointed and qualified.

In RA 7920 (The New Electrical Engineering Law), the term “commission” refers to the

In the reexamination of failed subjects in the examination for Registered Electrical Engineer, an applicant shall be allowed to retake, ____ times, only the subject/s in which he has obtained a grade below 50%.

The current chairman of the Board of Electrical Engineering is

Who is the chairman of Professional Regulation Commission?

Which one is NOT a requirement for the applicant to apply for registration as a registered electrical engineer?

Who is considered as the executive officer of the Board of Electrical Engineering?

The passing general weighted average rating for the licensure examination for Registered Electrical Engineers must be 70% with NO GRADE below ____ in any subjects in Mathematics, ESAS, and Electrical Engineering as required under Section 19(b) of RA 7920.

Based on Section 18 of the R.A. 7920, the minimum age requirement for qualifications of applicants for Registered Master Electricians Examination is at least ____ years of age

The minimum age requirement for applicants to become a Professional Electrical Engineer

Which of the following is NOT a qualification to become a member of the Board of EE?

All are considered as a practice of electrical engineering profession except one.

Which of the following is qualified as the Chairman of the Continuing Professional Development Council for Electrical Engineering?

The Energy Efficiency and Conservation Act of 2019 is

An act penalizing the pilferage of electricity and theft of electrical power transmission lines/materials, rationalizing system loss by phasing out pilferage losses as a component thereof, and for other purposes is

What does R.A. 9136 stand for?

Section 23 of Article III of RA 7920 — Issuance of Certification of Registration. The professional is required to renew license every ____ years upon payment of registration fee.

What is the term used when an American citizen is allowed to practice his profession, e.g., electrical engineering profession, here in the Philippines?

As specified by the Energy Regulatory Commission, a contestable customer is a customer with a demand of least ____ MW.

Any person guilty of committing any of the prohibited acts stated in the RA 11361 has the penalty for the first offense of arresto mayor or one month and one day up to ____.

What is PDC stands for in EPIRA?

Who is the current chairman of the Board of EE?

The electric power industry shall be divided into four (4) sectors, namely: generation, transmission, distribution and ____

Refers to the system of allowing any qualified person the use of transmission, and/or distribution system, and associated facilities subject to the payment of transmission and/or distribution retail wheeling rates duly approved by the ERC.

The Board of Electrical Engineering is composed of one chairman and how many members?

Which is not allowed to elect a member of PRC counsel?

Occupational Safety and Health Standards (OSHS) Rule ____ Electrical Safety.

In the writing of PEC 2009, what is the version of the NEC that was patterned to?

The Philippine Electrical Code Part 1 2009 was based on the National Electrical Code 2005 while the Philippine Electrical Code Part 1 2017 Edition was based on the National Electrical Code ____

The PEC is passed on the Board of Electrical Engineers last November 2017. The Philippine Electrical Code 2017 is Board Resolution number ____ series of 2017.

Motors must be labeled with the following nameplate rating, manufacturer’s name, etc.

Rule used to determine sizes and rating of circuit conductors and devices.

The disconnecting means for motor circuits shall have an ampere rating of at least 115% of the full load current rating of the motor.

A disconnecting means shall be located within sight from the motor controller.

The purpose of the PEC is to provide which of the following?

The PEC is intended for what type of applications by government bodies exercising legal jurisdiction over electrical installation.

Mandatory rules of the Code are identified by the use of the word _____.

The conductor used to connect the grounding electrode(s) to the equipment grounding conductor, to the grounded conductor, or to both, at the service, at each building or structure where supplied by a feeder(s) or branch circuit(s), or at the source of a separately derived system.

What is a system or circuit conductor that is intentionally grounded based on PEC?

A single electrode consisting of a rod, pipe, or plate that does not have a resistance to ground of ____ ohms or less shall be augmented by one additional electrode.

Which of the following is NOT permitted by the PEC under certain conditions as substitute for grounding?

What is a protective device designed to protect an individual against electric shock?

Which insulation color identify the grounded conductor of a branch circuit?

What is the color of the conductor used as a neutral?

The color reserved for use in equipment grounding conductor is

A 4-wire system has a high leg voltage that is indicated by a wire of color

Which of these location/s described partially protected locations under canopies, marquees, roofed and open porches subject to moderate degree of moisture in the PEC?

A building under construction is a ____ location.

Which location may be temporarily subject to dampness or wetness?

A load is considered as continuous if it is expected to continue for _____.

Which of the following installations are permitted in clothes closet?

In Rigid Metal Conduit (RMC) wiring, conduits shall be supported at least every ____ mm.

Which of the following that the fluorescent luminaires CANNOT be directly mounted?

Where conductors carrying alternating current are installed in metal enclosures or metal raceways, they shall be so arranged to avoid heating the surrounding metal by induction. To accomplish this, ____ shall be grouped together.

Installing more than three current carrying conductors in the same conduit requires

In rigid metallic conduit, the minimum electrical trade size is ____ mm.

Two switches in one box under one face-plate is called _____.

What is the UPS stand for?

The MAXIMUM distance from the flooring to the receptacle outlet in dwelling unit in mm:

What is the minimum lighting load required by PEC for an office measuring 20 m by 25 m?

What is the derating factor in each of 7 to 9 conductors in a raceway?

What is the maximum number of conductors in a raceway that does not need to be derated?

What is the current carrying of each conductor if 36-8.0 sq mm THWN copper conductors are installed in an auxiliary gutter?

In estimating the loading of a branch circuit, what loading shall be used for each receptacle?

The total load on overcurrent device located in a panelboard shall NOT exceed a certain percentage of its rating. What is this percentage?

What is the MAXIMUM number of overcurrent devices for a lighting and appliance that can be installed in a single cabinet?

What is the maximum allowable continuous load for branch circuit conductor?

The minimum size of conductors to be used for lighting purposes is

The minimum size of copper equipment conductor required for equipment connected to a 40 A circuit

Where receptacles are connected to a 30-A branch circuit, the maximum allowable cord and plug connected load shall NOT be more than ____ A.

A room air conditioner is to be attached to an individual branch circuit. If the load is 12 A, what is the minimum size of branch circuit required?

If an appliance has a motor load of 12-A and a heating load of 15-A, what is the required ampacity of the branch circuit conductors?

What size of branch circuit is required for a window air conditioner with a nameplate rating of 8-A if the circuit also supplies other outlets?

Whenever eye protection is needed, persons whose visions require the use of corrective lenses shall wear

Protection of workers from impact penetration from falling or flying objects.

Which of the following is/are hazardous practice/s?

Which of the following is NOT a hazardous practices?

What is the reason why incidents are not investigated?

Mann was heating oil to fry potato chips. The cooking oil all of a sudden caught fire; he poured water to extinguish the fire. Do you think this action was suitable?